We operate fully operational breaks and shears at our manufacturing plant in western Saskatchewan and can produce almost any kind of flashing your project requires in10’ lengths. Use the following information to find out which of our standard flashing you need, or the flashing you need isn't listed then simply provide us your drawing and measurements and we’ll take care of the rest.
 

Standard and Custom flashing is available in any of our stock colors in 29 and 26 gauge material. Heavier gauges may be available upon request.

ALL STANDARD FLASHING is bent to work on a 4/12 pitch unless otherwise requested.

​

​

​

 

COMMON STANDARD FLASHING USES
 

• Ridge Roll/Cap - Used horizontally where length side of roof panel meets wall panel below

• Gable- Used horizontally where length side of roof panel meets wall panel below

• Eave -Used to hide rafter end where roof slightly overhangs top of wall

• Drip - Used to seal above window or door and bottom of panel above

• Base - Used as a starter strip for panels at bottom of building

• J-Trim - Used as a cap for panel edges, typically around windows and doors

• Outside Corner - Used vertically on outside corner of building

• Inside Corner - Used vertically on inside corner of building

• Valley - Prevents leaks where two roof slopes create a valley

• Side/End Wall - Used to prevent leaks between upper side walls and roof sheets

• Snow Stop- Prevents snow buildup from sliding on roof, typically above windows and doorways

CUSTOM FLASHING

We are outfitted with breaks and shears capable of bending and cutting up to 18 gauge material in 10’ lengths. Whether your looking for a single piece or large quantities of custom bent flashing we can help. Our breaks are fully programmable so we can save your dimensions and custom trim requirements under your name or your company name for the next time you need to order.

Simply provide us with a drawing and the dimensions of your custom flashing requirements and we’ll do the rest.

For repeat orders, ask any of our locations for a custom  flashing form. Simply send in your drawing and dimensions and we’ll program your flashing requirements into our machines for any future orders.